|
|
|
View Cart
|
Micro-Volt 12 
The Micro-Volt is a 12 volt regulated power supply intended for use with Micro-Trak products.
The pre-assembled circuit measures 1 X 1 inches, and has a three terminal input/output connector.
The Micro-Volt will supply the short duration 2 Ampere pulses required by 8- 10 Watt Micro-Trak transmitters,
and may be used to power any Micro-Trak from automotive or 24 Volt aircraft power busses.
The power supply should be installed on a fused power bus.
Note that the power supply uses a common ground for input and output. In an automobile with negative ground, the center connection should be connected to chassis ground. Unlike many power supplies, the voltage regulator tab on the Micro-Volt is not connected to ground, so use care in your installation not to short the tab to chassis ground. Do not install a screw through the board to fasten the tab to the board, as this could cause a short. If required, the voltage regulator may be bent upwards and attached to an accessory heat sink. Additional Micro-Trak Products: Micro-Trak AIO - An self contained portable tracker. Micro-Trak TT4 - TinyTrak4 with a radio transceiver. Micro-Trak 300 - The original Micro-Trak. Micro-Trak BFT - A 35 watt Micro-Trak transmitter. Micro-Trak 8000 FA - An 8 watt, frequency agile Micro-Trak. Micro-Trak 8000 - An 8 watt version of the Micro-Trak 300. Micro-Trak 200 FA - A frequency agile version of the Micro-Trak 300. Micro-Amp - A power amplifier for the Micro-Trak 300. Micro-Trak VHF Antenna - An antenna for the Micro-Trak products. For additional information, please contact 
Micro-Volt 12 - $15.
Documentation: Micro-Volt 12 Manual - v2.0 - Current Version Micro-Volt 12 Manual |