|
|
|
View Cart
|
Micro-Trak RTG (Ready To Go) 
Byonics and VHS Products are pleased to announce the Micro-Trak RTG (Ready To Go), a 10 watt APRS 144.390 MHz Transmitter and controller designed for easy vehicle installation.
The MT-RTG is based on the TinyTrak 3 controller chip, and is available with a external GPS receiver and magnet mount SMA antenna.
The Micro-Trak RTG comes pre-configured, so please send us your desired callsign & optional SSID (ie: N6BG-5), and any other operating parameters which differ from the defaults in the config program (downloadable below). Even though it is shipped pre-configured, users can use the TinyTrak3 config program and a F-F null modem cable to change the settings later. See Sam Buchanan's review of the MT-RTG at VansAirForce forum. Additional Micro-Trak Products: Micro-Trak AIO - An self contained portable tracker. Micro-Trak TT4 - TinyTrak4 with a radio transceiver. Micro-Trak 300 - The original 300mW Micro-Trak, without the amplifier. Micro-Trak BFT - A 35 watt Micro-Trak transmitter. Micro-Trak 8000 FA - An 8 watt, frequency agile Micro-Trak. Micro-Trak 8000 - An 8 watt version of the Micro-Trak 300. Micro-Trak 200 FA - A frequency agile version of the Micro-Trak 300. Micro-Trak VHF Antenna - An antenna for the Micro-Trak products. Micro-Volt 12 - A 12 volt regulated power supply for Micro-Trak products. For additional information, please contact 
Micro-Trak RTG - $120.
The built Micro-Trak RTG on 144.39MHz and cable to interface to a 12V cigarette lighter and a serial GPS receiver with a DB-9 connector (such as our GPS2). The GPS and Antenna are not included.
Micro-Trak RTG, GPS2, Antenna Combo - $190.
Includes the built Micro-Trak RTG on 144.39MHz, GPS2 receiver, V3 magnet mount SMA antenna, and cable to interface to a 12V cigarette lighter and a GPS. NOTE: After placing an order for the MT-RTG, please leave your desired callsign, optional SSID, and any other preferred settings in the order notes, or a follow up email. Documentation: Micro-Trak RTG Manual TinyTrak3Plus configuration software Note: This transmitter operates on amateur radio frequencies, and requires a valid amateur radio license to use. |